Patent Pending. Price: $375.00 plus
$20.00 s/h |
Operating Instructions
Steps To Set Up Tool
1. Unpack tool and inspect for shipping damage.
2. Install Thickness Adjustor screw…rotating in a clockwise
direction until it just touches the aluminum crossbar (being
careful not to cross the threads).
3. Mount the tool on a bench or table of your choice using either
mounting screws or c-clamps (make sure clamps don't interfere
with the motion of the roller when the handles are depressed).
4. Remove plastic blade protector.
Steps To Prepare To Split Strings
1. Depress the handle to force the roller down away from the
blade.
2. Insert end of string (3-4 inches) from beneath the back side
out the front side and release the handle so the string becomes
pressed between the blade and roller (making sure the smooth
side of hide is always against roller surface).
3. You want to strip the first few inches of your string first,
and then take it out and feed it into the splitter from the front
side to finish the remainder of the string.
4. You will then split the rest of the string by gently and steadily
pulling the string from the front side to the back side (exiting
beneath the aluminum crossbar). The scrap portion being split
peels up above the blade. For best results, guide the incoming
string onto the roller by holding it with slight tension and
down near the base of the front side of the splitter near the
table or bench surface.
5. To set string thickness, turn the Adjustor Knob clockwise
to increase thickness (thicker), or counter-clockwise to decrease
thickness (thinner). Suggestion: practice on scrap string until
you get the feel of using the tool. |
